Dovre 2180CBBS, Installation Instructions And Operating Manual

Page: 48 / 182

If the glass in the appliance is broken or
cracked, it must be replaced before you can
use the appliance again.
Make sure that no stove window cleaner runs
between the glass and the cast-iron door.
Note : To gain access to the inside glass of the lifting
door of model 2180CBGD, you can tilt the door
forward 60°. Use a screwdriver (A) to turn the two
screws in the top of the door to the left; see next
figure.
Lubrication
Although cast-iron is slightly self-lubricating, you will
still have to lubricate moving parts frequently.
Lubricate the moving parts (such as guide
systems,hinge pins, latches and air slides) with
heat resistant grease that is available in the
specialist trade.
Touching up the finish
Small areas of damaged paint finish can be touched
up with a spraying can of special heat-resistant paint
finish available from your supplier.
Checking the seal
Check whether the sealing rope of the door is still
in good condition and works well. The sealing rope
is subject to wear and needs to be replaced in time.
Check the appliance for air leaks. Close any
chinks with stove sealant.
Let the sealant harden fully before you start a
fire in the appliance, because otherwise any
moisture in the sealant will form bubbles in the
sealant and cause a new air leak.
Panoramic lifting door: model
2180CBGD
Model 2180CBGD has a flat, panoramic lifting door.
The guiding system can be removed and the position
of the door can be adjusted.
Dismantling the guiding system
For dismantling, follow the steps below.
1. Lock the door by turning the two locks above the
door outward; see next figure.
2. Turn the two screws in the top of the door to the
left; see next figure. The door will now tilt forward.
3. Remove the front (with door and guiding system)
from the top part by removing the screws at top
left and right; see next figure.
18
Subject to change because of technical improvements