Dover OPW SiteSentinel Integra 100, Installation Manual

Page: 22 / 101

Doc. # : M1800, Rev. 06
Page 22 of 101
www.opwglobal.com
2.8.1 Console Board Inputs
Use the jumper settings on this page to set board inputs as desired.
J1 / J2 USB Host J16 (Silence Button & Alarm Light) J21 (RS-422 & RS-485)
J3 2x USB Host Pin Connection Pin Connection
J4 / J7 Reserved for future expansion module 1 Silence Button (+) 1 RS422 ISOLATED GND
J5 Modem Line 2 Silence Button (-) 2 RS422 Z
MDM1 Modem Module (P/N 75-2055) 3 Alarm Light (+) 3 RS422 Y
BT1 Real Time Clock Battery (3V, CR2032) 4 Alarm Light (-) 4 RS422 B
J6
12V Probe Sensor Barrier (P/N: 20-
4344)
5 RS422 A
J8 LCD Backlight Inverter J18 (SATA HDD Power) J19 (Output Relay) 6 RS485 ISOLATED GND
J9 Touch Screen Pin Connection Pin N/O 7 RS485 B/Z
J10 RJ-45 Ethernet 10/100 1 +5 V Out 1 N/C 8 RS485 A/1, B/2
J11 LCD Panel 2 GND 2 Common
J12 JTAG 3 N/O J20 (External Inputs)
Pin Connection
J13 (2x RS-232) J14 (RS-232) P2 - P5 Jumpers 1 Input 2
Pin Connection Pin Connection P2 RS-422 Termination 1-2 OFF, 2-3 ON 2 +12 V Out
1 RTS Output 1,3,8 GND P3 RS-422 2/4 Wire Selection 1-2 2-Wire, 2-3 4-Wire 3 Input 1
2 DTR Output 2 RX Input P4 RS-422 2/4 Wire Selection 1-2 2-Wire, 2-3 4-Wire 4 +12 V Out
3 ISOL GND 4 TX Output P5 RS-485 Termination 1-2 OFF, 2-3 ON
4 TX Output 5,6,10 No connect
J17 [Options Memory (Dallas
Chip)]
5 RX Input 7
RTS
Output
J22 (Lithium Battery)
J23 (Power
Entry)
6 DCD Input 9 CTS Input Pin Connection Pin Connection
7 No Connect 1 Battery Voltage Sense
1,
2 11, 25 VDC
Input
8 CTS Input 2 Battery GND
3,
4
GND
3 Battery Power (+)