user manual
DMx Inductive Probe Kit
introduction
Package Contents
HYD10099838
DMx Inductive Probe Kit
•
Inductive Probe with attached cable and signal conditioner
•
Inductive interface printed circuit board for wiring the inductive
probe to DMx (not shown)
•
Small slotted screwdriver (not shown)
•
A conduit fitting that threads into the base of the DMx cabinet
(not shown)
•
A nylon wire tie wrap
Overview
The optional
inductive probe kit provides a more accurate, temperature-compensated conductivity measurement inside the
wash tank. This probe is not susceptible to scaling in regions with hard water.
The following instructions explain how to install an inductive probe and connect it to a DMx dispenser.
Dispensers that are ordered with this option come with the kit packed separately.
Safety Precautions
WARNING!
Please read these warnings carefully and follow all applicable local codes and regulations.
THANK YOU FOR YOUR INTEREST IN OUR PRODUCTS!
TO AVOID SERIOUS PERSONAL INJURY AND PROPERTY DAMAGE:
protective clothing and eyewear when dispensing chemicals or other materials, when working in the vicinity
of chemicals, and when filling or emptying equipment.
read and follow all safety instructions in safety data sheets (SDS) for all chemicals.
observe all safety and handling instructions of chemical manufacturer.
dilute and dispense chemicals in accordance with chemical manufacturer‘s instructions.
regularly inspect equipment and keep equipment clean and properly maintained.
mix incompatible chemicals that pose hazards.
only to warewash reservoirs. Operating outside of these parameters will void manufacturer’s warranty.
WEAR
ALWAYS
NEVER
ATTACH
