Complete 101 Series Installation Manual
99-25517-I001 July 2022 Rev. B
87 |
P a g e w w w . a n t h o n y i n t l . c o m
Hold Open
Once all hinges are installed, use the following instructions to install the hold open.
1.
Position the hold open onto the pivot and screw on tightly.
2.
Once the hold open is in place, ensure everything closes and opens with ease. If not, ensure all hinges are correctly placed and
screws are fully tight.
3.
If the door does not close with ease, adjust the height of the bottom wiper by loosening the screws and adjusting height. When the
door is properly in place, torque must be added to the hinges.
Figure 18.15: Hold Open
4.
With the wrench key in hand, rotate the adjustment capstan clockwise. Rotate the pin approximately 1.5 turns, until the fourth
hole is reached.
Figure 18.16: Torquing Hinges
5.
Once at the fourth hole, insert the stopper pin and remove the wrench key.
6.
After all, the pins are in, check the door closing tension.
7.
To achieve proper door closing force, move the tension stopper pin from one hole into the next, in either direction, by using the
wrench key.
NOTICE
Note – All hinges need to be torqued equally
