Complete 101 Series Installation Manual
99-25517-I001 July 2022 Rev. B
78 |
P a g e w w w . a n t h o n y i n t l . c o m
Section 18 – Pass-Thru Door Installation
Following the instructions will guide you on how to Install the Pass-Thru Door Assembly on Pass-Thru Frame.
PROTECTIVE GEAR NOTICE
Protective Eyewear– Potential risk of eye injuries, protective eyewear required when
performing this, and any other associated tasks.
Protective Gloves– Potential risk of injury to your hands, protective gloves required when
performing this, and any other associated tasks.
Footwear Protective – Potential risk of injury to your feet, wearing protective footwear is
required when performing this and any other associated tasks.
1.
Hold the door on each side, with the handle facing forward. Lift door, align torque rod to insert into TorqueMaster™ socket at the
base of the frame.
Figure 18.1: Inserting door Torque Rod into TorqueMaster
2.
Now we will proceed to engage and lock the hinge pin into place, and prepare the SOCKET (hinge pin plug) receptacle by using
Dielectric grease on the socket of the frame before inserting the door hinge pin. (Anthony P/N: 98-25497-0001).
3.
Apply a minimum of 3 grams of dielectric grease (Anthony P/N: 98-25497-0001) to fill the holes in the socket as shown in Figure
18.2.
