Douwe Egberts Cafitesse 700, Back Office Manual

Page: 58 / 265

*errors will be logged ** errors will not be logged *** UI-error messages: higher priority overrules lower priority, with same priority message of first appearance is shown
July 2004 3 - 20
No. Description Over-
rules Set condition Reset condition Remarks Cause Remedy Prio-
rity***
88** All BIBs are empty 85, 86 Software: all the in
CONFIGURATION
installed BIBs are empty. Automatically when one
of the underlying errors
(40-42) has been cleared Only shown in
user interface
without error
number See errors 40-42See errors 40-42 60
89** No drinks except hot or
cold water are available Software: multiple
actuators/sensors are
defective Automatically when at
least one drink except
water can be prepared Only shown in
user interface
without error
number See ‘cause’ of active
errors listed in the error
log See ‚remedy’ of active
errors listed in the error log 68
90* Data checksum error,
parameter .field 1 (Initial) memory test
failed After startup of the
dispenser, when the
problem has been
solved. The memory test of the
MCM detected a memory
failure. Replace the MCM circuit
board. 210
91* Flash file system corrupt After initialization failure
of the MCM flash file
system Automatically after a
successful initialization of
the flash file system
(after startup of the
dispenser???) Download via
PC-Service tool 1. Flash file system not
available
2. MCM circuit board
defective
1. Reload the CBX-file via
download file from PC
service tool.
2. Replace MCM circuit
board.
220
92* Data file missing in flash
file system When at startup of the
dispenser an invalid data
file (CBX) is found in the
flash file system After startup of the
dispenser, when the
problem has been
solved. Download via
PC-Service tool 1. Flash file system is
not available
2. MCM circuit board is
defective.
1. Reload the CBX file via
download file from the
PC service tool
2. Replace the MCM circuit
board.
209
93* Backup memory failure Hardware or checksum
error After startup of the
dispenser, when the
problem has been
solved. 1. Content of backup
flash file is invalid.
2. User interface circuit
board defective
1. Do a BACKUP in the
service menu to reload
the content of the
backup flash file.
2. Replace user interface
circuit board.
204
94 Water valves are not
calibrated All Software parameter of at
least one outlet valve is
indicated as ‚not
calibrated’ Automatically when
parameters of all
installed outlet valves
indicate ‚calibrated’ 1. Installation sequence
not executed
2. New MCM
3. New data on MCM
1.-3. Calibrate valves 150