Douwe Egberts Cafitesse 700, Back Office Manual

Page: 32 / 265

July 2004
Installation /
Putting into Operation
2 - 20
1
Fig. 7
• Take the respective product placement
sticker (1) from the country kit and glue them
to the panel of the water distribution system.
(Fig. 7)
• Take the sticker 'ON/STANDBY/CLEAR' from
the country kit, and glue it on the door cover
above the 'ON/STANDBY/CLEAR'-switch (2).
(Fig. 8)
• Take the 'PULL HERE TO RELEASE'-sticker
from the country kit and glue it on the
trough-clamp.
• Insert the product packs. (Fig. 7)
• Program the dispenser in accordance with
customer’s demands (see chapter 4).
Switching the dispenser ON
• Open the water tap.
• Plug in the mains plug.
• Open the right-hand dispenser door. (Fig. 8)
• Switch on the dispenser with the
'ON/STANDBY/CLEAR'-switch button (2).
(Fig. 8)
• The outlet valves must be calibrated as
described below.
Calibrating the outlet valves
• Place a measuring container with a capacity
of 180 ml beneath the concerned outlet.
• Activate the programming mode using the
blue service tag. (Fig. 9)
(see also Back Office Manual, chapter 4)
• In the service menu, select submenu "Calibrate".
• Carry out the calibration of the hot water
outlet valve in accordance with the flow
charts on the following page.
Fig. 8
2
Fig. 9
stop
20m
m
Please make your selection
Douwe Egberts Coffee Systems
small
medium large
Cafitesse 700 - Installation / Puttting into Operation