Douwe Egberts Cafitesse 700, Back Office Manual

Page: 27 / 265

July 2004
Installation /
Putting into Operation
2 - 15
1
2
3 4
5
6
1 XXXXXXXXXXXXX
2 XXXXXXXXXXXXX
3 XXXXXXXXXXXXX 4 XXXXXXXXXXXX
5 XXXXXXXXXXXX
6 XXXXXXXXXXXX
• As standard the heating capacity of the
dispenser is set to 3000 W (230 V). If neces-
sary, adjust the heating capacity acc. to the
selected configuration.
DANGER: Disconnect the dispenser from
the mains before changing
over the heating capacity.
There is a danger of destroy-
ing the dispenser! The heating
capacity may only be changed
over by a trained service
technician.
The slip-on rotary switch is a
service tool that may only be
used by the service technician.
It must be removed after the
heating capacity has been
changed.
• Remove the drip tray (1) with drip grid ((2)
and, if required, cup carriers (3), and the
splash panel (4). (Fig. 3)
• Position the rotary switch (5) (service tool) to
switch over the heating. (Fig. 4)
• Adjust the heating according to the previously
selected configuration (see following pages).
Ensure correct adjustment!
Adjusting the heating capacity
Fig. 3
1
3
2
Fig. 4
4
5
ATTENTION: Under all circumstances re-
move the rotary switch after
changing over the heating.
• The following power supply cables must be
used for the adjusted heating capacities:
Position 1–4 => 3x10AWG
Position 5 => mains cable 3x6 AWG
to be provided country-specific
Position 6 => mains cable 3x14 AWG
to be provided country-specific
Connection capacity
=
Heating capacity + 200 W max.
• Remove the rotary button.
• Assemble the small dummy cap.
• Adhere the corresponding sticker for the set
values to the rating plate.
Cafitesse 700 - Installation / Puttting into Operation