Douwe Egberts Cafitesse 700, Back Office Manual

Page: 216 / 265

July 2004
5F - 14
Functions - cooling system
Fig. 2
6
• Disconnect the dispenser from the power
supply system and close the water tap.
• Open the right dispenser door and remove
the locking screw.
• Remove the left housing cover (1) and the
left front panel (2) and then undo the cable
harness for the delivery button. (Fig. 1)
• Remove the combined trough (3) and the
water distributor panel (4). (Fig. 1)
• Take out the water distributor (5). (Fig. 1)
• Remove the product packs (6) from the
cooling compartment and close the cooling
compartment door. (Fig. 2)
• Disassemble the cooling compartment (7)
(Fig. 1). (See chapter F.2.6)
ATTENTION: The cooling compartment is
heavy and must be held firmly.
• Put the cooling compartment down in an
upright position or lay it down on its right
side.
• Use a pair of pliers to pull the spring (8)
out of the support. (Fig. 3)
• Pull out either the bottom pin (9) or the top
pin on the hinge rod (10). (Fig. 4)
• Undo the retaining clamps of the hinge
segment (11) from inside and then pull out
the segment toward the bottom. (Fig. 4)
• The assembly is carried out in reverse
order.
• When the top lid (12) had been dis-
mounted, it must be adjusted after reas-
sembly. To do so, turn the crosshead screw
(see arrow), until the top lid is flush with
the cooling compartment. (Fig. 4)
F.2.8 Disassembly of the spring and the door mechanism of the cooling compart-
ment
Fig. 4
9
11
10
Fig. 3
8
Fig. 1
5
1
2
7
4
3
12
Cafitesse 700 - Functions - cooling system