Douwe Egberts Cafitesse 700, Back Office Manual

Page: 214 / 265

July 2004
5F - 12
Functions - cooling system
Fig. 4
9
Fig. 5
• Remove all plugs in the plug connector (9)
from the socket housings and undo all
cables from the cable fastening strips.
(Fig. 4)
• Lift the cooling compartment further up until
the gas spring on the right side underneath
the cooling compartment falls out of its
holder.
• Hold the cooling compartment and unscrew
the gas spring at the top, if necessary with
a pair of pliers.
ATTENTION: Only apply the pliers at the
top part of the gas spring as
otherwise this could impair the
correct functioning of the gas
spring.
ATTENTION: The cooling compartment is
heavy and no longer supported
by the gas spring! Therefore
do not rest the cooling com-
partment on the leaf spring!
• Undo the leaf spring and swivel the cooling
compartment downwards again and rest it
on the console.
• Remove the locking rings (10) on the left
and right hinge bolts. (Fig. 5)
• Pull the right and left hinge bolts inwards
out of the support.
ATTENTION: The cooling compartment is
heavy and must be held firmly
when removing the bolts.
• Take out the cooling compartment and put
it aside.
ATTENTION: Do not place the cooling
compartment on the heat
sinks!
• The assembly is carried out in reverse
order.
On assembly, note the following:
• Do not forget to install the lever rod of the
gas spring when inserting the hinge bolt on
the right-hand side.
10
Cafitesse 700 - Functions - cooling system