Douwe Egberts Cafitesse 700, Back Office Manual

Page: 212 / 265

July 2004
5F - 10
Functions - cooling system
7
• Disconnect the dispenser from the power
supply system and close the water tap.
• Open the right dispenser door and remove
the locking screw.
• Remove the left housing cover (1) and the
left front panel (2) and then undo the cable
harness for the delivery button. (Fig. 1)
• Remove the combined trough (3) and the
water distributor panel (4). (Fig. 1)
• Take out the water distributor (5). (Fig. 1)
• Remove the product packs from the cooling
compartment and close the door of the
cooling compartment.
• Press the jack latch downward and then
swivel the cooling compartment (6) 90
°
upward until the leaf spring latches into
place on the left side. (Fig. 1)
• Undo the respective 2-pin plug (7) for the
temperature sensor on the console (8).
(Fig. 2)
• Dismount the old temperature sensor.
• When mounting the new temperature
sensor:
– Apply a layer of 0.4 mm heat-conductive
paste to the entire metal sleeve of the
temperature sensor.
– Insert the temperature sensor into the
cooling compartment as far as possible
(up to the black mark of the cable), and
fix the cable (10) with the clip (11).
(Fig. 3)
ATTENTION: Check the distance marked on
the temperature sensor (12) (the
correct measurement is 85 mm
from the end). If necessary, cor-
rect the mark (13) (e. g. using a
felt tip). (Fig. 4)
Make sure that the temperature
sensor reaches into the cooling
compartment as far as possible.
F.2.5 Replacement of the temperature sensor
Fig. 1
5
1
2
6
4
3
Fig. 2
10
Fig. 3
11
Fig. 4
85 mm
12
13
8
Cafitesse 700 - Functions - cooling system