Douwe Egberts Cafitesse 700, Back Office Manual

Page: 209 / 265

July 2004
5F - 7
Functions - cooling system
Fig. 2
8
7
Fig. 3
10
11
• Disconnect the dispenser from the power
supply system and close the water tap.
• Open the right dispenser door and remove
the locking screw.
• Remove the left housing cover (1) and the
left front panel (2) and then undo the cable
harness for the delivery button. (Fig. 1)
• Remove the combined trough (3) and the
water distributor panel (4). (Fig. 1)
• Take out the water distributor (5). (Fig. 1)
• Remove the product packs from the cooling
compartment and close the door of the
cooling compartment.
• Press the jack latch downward and then
swivel the cooling compartment (6) 90
°
upward until the leaf spring latches into
place on the left side. (Fig. 1)
• Undo the respective 4-pin plug (7) for the
cooling unit on the console (8). (Fig. 2)
• Remove the exhaust air plate (9) from the
heat sink. (Fig. 3)
• Undo the two screws (10) in the centre of
the heat sink (above and below the fan)
and then remove the cooling unit (11). Hold
the screws during this procedure. (Fig. 3)
9
F.2.4 Replacement of the Peltier element
Fig. 1
5
1
2
6
4
3
Cafitesse 700 - Functions - cooling system