Douwe Egberts Cafitesse 700, Back Office Manual

Page: 200 / 265

July 2004
5D - 10
Functions - product delivery
D.7.3 Dispenser foot for thermos flasks
• If the beverage delivery operation is to be
carried out into higher thermos flasks, a
special dispenser foot for thermos flasks
can then be installed under the Cafitesse
700 pot version.
Installation of the 'thermos flasks' kit:
• Disconnect the dispenser from the power
supply system and close the water tap.
• Disconnect the water supply system from
the dispenser.
• Remove the drip tray (1) and drip grid (2).
(Fig. 1)
• Remove the cup carrier (3) and splash
panel (4). (Fig. 1)
• Remove all product packs (BIB) from the
cooling compartment.
• Drain the water out of the boiler. (See
chapter A.2)
WARNING: The water running out of the
boiler is hot. There is a risk of
being scalded. Keep your
hands and other parts of your
body away from hot water.
• Place down the dispenser on its rear side.
DANGER: Make sure that the mains
cable is not damaged during
this procedure. If necessary,
disassemble the mains cable
beforehand. (See chapter 5K)
ATTENTION: The dispenser weighs approx.
71 kg. It should therefore be
carried by 2 persons.
• Remove the screws (5) on both sides and
then take off the foot panels (6) from the
base stay (7) of the dispenser. (Fig. 2)
• Use a screwdriver to penetrate the bottom
of the dispenser at the location (8) provided
for this purpose. (Fig. 3)
• Push the pre-assembled dispenser foot for
xxxxxxxxx xxxxxxx
xxxxxx xxxxxxxxxx
Fig. 1
1
4
3
2
Fig. 2
Fig. 3
5
6
8
7
Cafitesse 700 - Functions - product delivery