Dot Hill Systems SANnet II 200, Installation, Operation And Service Manual

Page: 66 / 186

5-2 SANnet II 200 SCSI Array Installation, Operation, and Service Manual • June 2005
5.2 Front-Panel LEDs
The drive LEDs are located between the rows of drives on the front panel (see the
following figure). The system operation LEDs are located on the right ear of the
chassis.
Figure 5-1 Front-Panel LEDs
The following figure shows the front panel LEDs and the Reset button.
Use a paperclip to push the Reset button to silence a failed component alarm. See
“Silencing Audible Alarms” on page 6-4 for more information about silencing audible
alarms.
SNGL LED Inactive (no bus configuration; invalid state)
Controller Module:
ACTIVITY LED (Inactive (controller not busy)
Center LED (status symbol) Slow blinking green: good primary controller
Solid green: good secondary controller
Right LED (battery symbol) Blinking green if battery is charging
Solid green if battery is fully charged
Ethernet port LEDs Inactive
Power/fan module LEDs Solid green
Event module LEDs Solid green
Table 5-2 Back-Panel LED Status When Array Is First Powered On (2 of 2)
Disk 0
Disk 1
Disk 2
Disk 3
Disk 4
Disk 5
Disk 6
Disk 7
Disk 8
Disk 9
Disk 10
Disk 11
Power
Fan
Temp
Reset
Event
LED 1
Drive
LED 2
LED 3
LED 4
Drive
LED 5
LED 6
button