Dot Hill Systems SANnet II 200, Installation, Operation And Service Manual

Page: 150 / 186

F-4 SANnet II 200 SCSI Array Installation, Operation, and Service Manual • June 2005
To access the array through an Ethernet connection, follow the procedures in “Setting
Up Out-of-Band Management Over Ethernet” on page 4-28. To access the command
prompt described there from a Windows 200x Server or Windows 200x Advanced
Server, perform this step:
●
Choose Programs → Accessories → Command Prompt.
F.3 Enabling a Windows 200x Server to Recognize
New Devices and LUNs
Before beginning this procedure, make sure that you are using a supported SCSI host
bus adapter (HBA) such as an Adaptec 39160. Refer to the
SANnet II 200 SCSI Array
Release Notes for current information about which HBAs are supported.
Also make sure that you are using a supported driver for your HBA. For the Adaptec
39160, use FMS V4.0a or later.
1. Boot your system and verify that the host bus adapter (HBA) basic input/output system
(BIOS) recognizes your new SCSI device(s).
Note –
While your system is starting up, you should see your new SCSI device(s).
2. If a Found New Hardware Wizard is displayed, click Cancel .
You are now ready to format your new device(s).
3. Open the Disk Management folder.
a. Right-click the My Computer icon to display a pop-up menu.
b. Select Manage .
c. Select the Disk Management folder.
d. If a Write Signature and Upgrade Disk Wizard is displayed, click Cancel .
A Connecting to Logical Disk Manager Server status message is displayed.