Dot Hill Systems SANnet II 200, Installation, Operation And Service Manual

Page: 120 / 186

B-10 SANnet II 200 SCSI Array Installation, Operation, and Service Manual • June 2005
1. Choose View
→
Agent Options Management .
The Agent Options Management window is displayed.
2. Select the Enable JBOD Support checkbox.
3. To immediately display the JBOD array in the main window, you must probe for new
inventory. Choose View → View Server and click Probe .
4. Click OK .
The JBOD array is displayed in the main window.
In a single-bus configuration, both ports of the JBOD array are connected to one HBA
on the server, as shown in the following example:
Figure B-5 Single-Bus Configuration
In a split-bus configuration, each port is connected to its own HBA, as shown in the
following example. A SAF-TE limitation prevents the main window from showing the
drives connected to port A and port B. The program can only monitor the JBOD from
the server connected to port B as shown.
Figure B-6 Split-Bus, Dual-Server Configuration