Setting the spray pattern
Protective equipment:
Use ear protection
Eye protection
Respiratory protection device
Protective workwear
Protective gloves
You can vary the size of the
spray pattern by adjusting the
distance of the spray gun to the
work piece and the selected
nozzle size.
1. Use valves in control cabinet to adjust the
material pressure.
6
Operation
6.1
Safety recommendations
WARNING!
Danger of explosion due to chemical
reactions
Material, halogenated hydrocarbon-based
rinsing agent or cleaning agent can
chemically react with aluminum compo-
nents of the product. Chemical reactions
can cause explosions. Serious injuries
and death can be the consequence.
– Only use rinsing agents and
cleaning agents that do not contain
any halogenated hydrocarbons.
NOTICE!
Material damage due to dried material
residues
If material residues dry in the product,
that can harm components.
– Rinse product immediately after
each use.
6.2
Checks
1. Perform the following checks during oper-
ation:
Check spray gun for cleanliness.
Check O-rings for correct seating and
tightness.
Check material pressure in relation to
the nozzle used.
Check nozzle for blockage.
Check spray gun for material leakage.
6.3
Rinsing
6.3.1 Safety recommendations
NOTICE!
Material damage due to unsuitable
rinsing agent
If the rinsing agent reacts chemically with
the components or the material, compo-
nents get damaged.
– Use only the rinsing agents that are
compatible with the components and
the material.
– Refer to safety data sheet of mate-
rial manufacturer.
6.3.2 General notes
When rinsing, use fluid to remove inner
soiling from components.
6.3.3 Rinsing
Protective equipment:
Use ear protection
Eye protection
Respiratory protection device
Protective workwear
Protective gloves
The spray gun must be rinsed:
After end of work
Before every change of material
Prior to cleaning
Prior to dismantling
Operation
01/2017
EcoGun AL AUTO - MSG00012EN
10/40
