Dorner iDrive 3200 Series, Installation, Maintenance & Parts Manual

Page: 17 / 48

851-702 Rev. A 17 Dorner Mfg. Corp.
3200 Series iDrive Belt Conveyors
Preventive Maintenance and Adjustment
4. Slide the idler pulley assembly (Figure 43, item 1) out
of the headplate on the opposite side.
Figure 43
Figure 43
5. Remove the pulley shaft assembly: remove the clip ring
(Figure 44, item 1) and washer (Figure 44, item 2)
from one side of the pulley assembly.
Figure 44
Figure 44
6. Slide the shaft assembly (Figure 45, item 1) out of the
pulley (Figure 45, item 2) .
Figure 45
Figure 45
B
−
Transfer Tail Pulley Removal
1. Temporarily support the transfer tail assembly.
Figure 46
Figure 46
2. On one side of conveyor, remove the two (2) back
fastening screws (Figure 47, item 1) , and the two (2)
front fastening screws (Figure 47, item 2) .
Figure 47
Figure 47
3. Remove the inner spacer (Figure 48, item 1) .
Figure 48
Figure 48
1
1
2
2
1
1
2
1