Dorner 3200 Series, Installation Manual

Page: 10 / 58

Dorner Mfg. Corp. 8 851-703 Rev. A
Aluminum Conveyors
Assemble
Figure 10
Figure 10
Attach Conveyor to Stands
1. Fasten brackets (Figure 11, item 1) to support stand
with mounting screws (Figure 11, item 2) , washers
(Figure 11, item 3) and nuts (Figure 11, item 4) .
Figure 11
Figure 11
2. Tighten screws (Figure 11, item 2 and 5) to 60 in-lb (7
Nm).
3. Attach to conveyor stand.
Install Return Rollers
Cleated Belt and 2–6¨ (51–152 mm) Wide
Flat Belt Conveyors
1. Locate return rollers. Exploded views shown in Figure
12 for flat belt and Figure 13 for a cleated belt.
Figure 12
Figure 12
Figure 13
Figure 13
2. Remove screws (Figure 12, item 1) or (Figure
13, item 1) and clips (Figure 12, item 2) or (Figure
13, item 2) from roller assembly.
3. Install roller assemblies (Figure 14, item 1) as shown.
Tighten screws (Figure 14, item 2) to 60 in-lb (7 Nm).
Figure 14
Figure 14
NOTE
Mounting brackets for flat belt conveyors
shown.
1 3
2
5
1
4
2 3
1
2
2
1
1
2
2
1
2
1
1