1
99131
Programming Instructions
Disclaimer: ALL KEY FOBS MUST BE PRESENT AND REPROGRAMMED WHEN PROGRAMMING NEW FOBS.
1.
Close and lock all doors with the driver's side power lock / unlock switch located on driver’s door panel.
2.
Insert key into ignition and remove it from the ignition cylinder at least 10 times within 10 seconds, if
successful your hazard lamps will flash.
ATTENTION: *** Withdraw key completely from ignition cylinder each time. If this procedure is performed to
fast, system will not enter programming mode.
3.
Insert key into ignition and turn to the ACC position.
4. Within 5 seconds, push ANY button on the keyless remote. Your hazard lamps will flash. NOTE: Do not press
the button on the remote more than one time or the programming will not be successful.
5.
To program all remaining new or old remotes, Unlock then Lock all doors remote. Your hazard lamps
will flash. Repeat this step for each remote (including any existing remotes).
6.
Turn key to the off position, remove key from the ignition. Unlock door using switch on door panel and
open driver’s door.
7.
Test remote(s).
