Basic safety instructions
Technical Manual
10
04048135 - 2020/10
dormakaba access manager 92 30
9230-K7, TP4-Client
2 Basic safety instructions
This product has been built to state-of-the-art standards and in line with established safety
regulations. However, hazards for persons and property may arise when handling the product.
Read and observe the following safety instructions before using the product.
2.1
Assembly and installation
Check the device for visible damage caused by transport or incorrect storage. Do not start up
any damaged device!
Assembly and installation of the product may only be done by skilled personnel (see chapter 1
Target group).
Mains voltage installations may only be carried out by a certified specialised company or au-
thorised electricians.
When installing/inserting the product in end-use equipment all requirements of the men-
tioned test standards must be fulfilled.
The product should only be installed in locations which fulfil the environmental and technical
conditions specified by the manufacturer.
The manufacturer is not liable for damage arising due to improper handling or incorrect in-
stallation.
2.2
Service and maintenance
Conversions and modifications to the product may only be done skilled personnel (see chapter
1 Target group). Any conversions and modifications performed by other persons will exempt
us from any liability.
The elimination of faults and maintenance work may only be performed by skilled personnel
(see chapter 1 Target group).
2.3
Accessories and spare parts
Accessories and spare parts must meet the manufacturer's technical requirements. This is
guaranteed if original dormakaba accessories and spare parts are used.
