WARNING
4
"This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2)
this device must accept any interference received, including interference that may cause undesired operation.
Note: This equipment has been tested and found to comply with the limits for Class B digital device, pursuant to part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful interference in a residential installation.
This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference
by one or more of the following measures:
-Reorient or relocate the receiving antenna.
-Increase the separation between the equipment and the receiver.
-Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
-Consult the dealer or an experienced radio/TV technician for help.
Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate this device."
*
DO NOT
leave children unattended on or beside the recliner.
*
DO NOT
use your recliner as a step stool.
*
DO NOT
sit on the edge of the seat, armrests or on the backrest as this could make the recliner tip over.
*
The power unit is intended to be correctly orientated in a vertical or floor mount position.
*
Do not use the unit if it is damaged or broken.
*
Keep away from heat to avoid glazing, melting or scorching.
*
Read all instructions before using.
*
Caution: Adult assembly required.
Summary of Contents for DA2051209
Page 7: ...7 Step 2 Attach the plug wire C to the wire on the seat frame B with the cable clamp C C C A B...
Page 8: ...Step 3 8 Attach the control panel E to the plug wire C with the cable clamp E E E C C C A B...
Page 9: ...Step 4 9 Attach the adapter D to the plug wire C with the cable clamp D D D D C D E A B...
