Doosan NHM Series, Manual

Page: 8 / 38

6
NHM/NHP Series NHM/NHPATCE29
③
In the [ rd-off ] screen, press the up arrow key to display [ Org.S - - ] .

[ Org.S - - ] : Origin mode
④
From the [Org.S - - ] screen, press and hold the SET key for 10 seconds. The screen will
blink and switch to [r 0001 ] .

[ r 0001 ] : Return to the start screen
11) Turn off the machine and turn it back on. This is the completion of resetting the reference
point.
2. Adjust the position of Magazine sub changer
1) Adjust the position of the sub changer and the
magazine chain pot
①
Move the tool pot #1 to the changer position,
and install the centering fixture between tool
pot and sub changer.
②
Use the center bar to locate them. Check to
see if the home position of the magazine is
misaligned, or if the sub changer is horizontally
misaligned with the magazine chain pot.
※
This correction work should be performed
together with adjustment of the magazine home
position.
Centering
Bar