Brochure Part Number: P506194 04/21
Installation Guide
This manual is the property of the owner. Donaldson Company reserves the right to change design and specifications without prior notice. Do not make any
system modifications or adjustments that would alter the original design. Modifications may result in denial of warranty coverage. Consult your Donaldson
dealer if you have questions regarding the assembly, operation, maintenance or warranty. Illustrations are for reference only as actual product may vary.
Servicing Guide
shop.donaldson.com
1. Lubricate the threads.
Lubricate threads of filter head
with clean oil or fuel
Failure to do this could result
in thread galling.
2. Apply thin film of clean
motor oil or fuel to gasket.
Lubricate seal(s) with clean oil.
Do not use grease or rubber grease.
3. Align threads. Spin filter
until gasket contacts.
Spin the new filter on until
the top of the gasket first contacts the
sealing surface.
4. Hand tighten the filter.
Tighten per the guidance of
the icons which appear on the
filter element. Do not over-tighten.
Ensure the drain valve is firm hand
tight.
5. Install water collection
bowl (if applicable)
Unscrew the Twist&Drain valve
from the base of the filter. Screw the
water collection bowl into the base of
the filter and tension firm hand tight,
then refit the Twist&Drain valve into
the base of the bowl and tension firm
hand tight.
6. Prime fuel system
As per the manufactures
recommendation
7. Start engine and check
for leaks
Starting may take longer than
normal for the first start.
8. Stop engine
Stop engine and recheck for
leaks
9. Drain water daily
1/4 twist of the Twist&Drain
valve. Once any water has
been drained, re-tighten the valve until
firm hand tight. A tube may be pushed
over the drain spigot to aid collection of
drained fluid.
