Downflo Workstation, DWST 4-1 to 6-4
A8
Soft Sided Acoustical Booth
Soft Sided Acoustical Booth Assembly
DWST Models 4-2, -3, -4
1. Position the power modules in-line so fronts are even and two sides are touching face-to-face. Position the first power module
and remove lifting eyes, repeat this for each additional power
module.
2. Remove and reuse the existing bolts and washers to install the
joining strips in between the power modules.
DWST Models 6-2, -3, -4
1. For DWST Models 6-2 and -3, check assembly drawings for
power module spacing positions. Also, a spacer panel will
need to be installed in between the power modules on these
models. See drawings for details.
2. Install the side panels on each end of the power module
assembly. Remove and reuse the existing bolts and washers
on the front of the cabinet.
DWST Models 4 and 6
3. Install the side and top angles (3 places) with the existing
hardware from the front of each power module. Attach the end brackets (2 places) to the outer ends of each power module
with the provided hardware.
Note: for the DWST Models 4-2, -3, -4 only- Four (4) holes will need to be drilled in the front panel of the power module in
order for the end brackets to be attached. See Bracket Detail
for hole location and size.
4. Install the mounting angles (2 places) just below the sprinkler
couplings on the power module. Remove and reuse the
existing bolts and washers.
5. Insert the foot pad and corner bracket into the front legs.
6. Insert the eight (8) roller hooks into the side channel. Install
one end of the side channel into the end bracket mounted to
the power module. The other end of the side channel should
be installed into the corner bracket. Repeat these steps for the
opposite side of the collector.
7. Install each end of the front channel into the corner brackets
on each of the front legs. The front channel should extend past
the side channels in order to lock in the roller hooks. Square
the entire frame assembly and tighten all set screws on the
end, corner, and coupling brackets. Anchor the leg foot pad to the floor.
8. Install the self-adhesive Velcro strip around the top of the channels and angles on the power module. Install the clear plastic
roof.
9. Install the self-adhesive Velcro strip down the outside of the side angles (2 places) and on the outside surface of the front
legs. Hang the tinted side curtain on the roller hooks. Attach the side curtain to the Velcro strips. Repeat this for the opposite
side of the booth assembly.
Bracket Detail
8.13
1.00
1.25
0.281 Dia typ.
