PSS5000/TEMA/803046/14
PSS 5000 – Technical Manual
5 Installation (Menu 2)
4.
Perform a Master Reset on the PSS 5000.
Note:
This prepares the PSS 5000 for the new
setup.ini
file, which is not
deleted during a Master Reset.
5.
Syntax errors in the
setup.ini
file are reported in the file
/pss_proc/sys/bel.txt
.
For more information about parameter descriptions, see the Software Re-
lease Document (SRD) for the actual Application Program.
5.7.1
Memory Module (Menu 2.7.1)
Description of Memory
Module menu
From the
Memory Module
menu you can configure the number of memory
modules installed in the PSS 5000. This menu is only available using the local
service panel.
To configure the number
of memory modules with
local service panel
The number of memory modules, also known as peripheral devices, can be
configured using the local service panel.
1.
Press
to move to the
INFORMATION 1
menu.
2.
Press , , , , , , ,
to
move
to
the
PERIPHERAL CONF
2.7
menu.
3.
Press the buttons in the sequence shown to move to sub-menus.
4.
Use
and
to select the correct number of modules present.
5.
Press
OK
.
The
NEW SETUP RESET NOW
sub-menu appears
6.
Press
OK
to make the changes to the changed parameter values.
To configure the memory
modules in the setup.ini
file using FTP
This procedure describes how to use the
setup.ini
file to configure the number
of memory modules present in the PSS 5000.
Note:
The
setup.ini
file can be downloaded from or uploaded to the PSS 5000
using any FTP client (WP_FTP, CuteFTP) or from a command line us-
ing
ftp.exe
.
1.
Download the
/pss_mem/2/appl/setup.ini
file.
2.
Open the file with an editor and locate the heading
[Peripherals]
.
3.
Find the
PaymentMemoryModuleCount
parameter and change the value to
match the actual number of memory modules present in the PSS 5000.
4.
Upload the modified
setup.ini
file to
/pss_mem/2/appl
in the PSS 5000.
5.
Perform a Master Reset on the PSS 5000.
