Domino G Series, Product Manual

Page: 85 / 172

Name Description
Mode Select what action will occur when the printer receives data:
• Print all - Print all messages from the sender. After the •
last message is printed, the printer will go to a "NO
DATA" state and wait for new data. If the product detect
sensor is triggered when there is no data, the printer will
stop and show an error.
• Print last - Only print the last message from the sender. •
•
Print last and repeat - Only print the last message from •
the sender and continue to print the last message until
new messages are received.
Data type Select the VDC data type:
• JSON •
•
Raw data •
•
Customize. •
Connection Select the connection method:
• TCP/IP •
•
COM (RS485) •
•
INPUT •
•
Barcode scanner (connected via USB). •
Response VDC Data Turn this function On, to send a response to the sender when
VDC data is printed.
Response VDC Command Turn this function On, to send a response to the sender when
VDC data is received.
Controller port
Note This setting is only valid if Connection is set to
TCP/IP .
Select the printer's communication port.
Default: 2030
COM Port
Note This setting is only valid if Connection is set to
COM .
Select the printer's communication port.
Default: COM0
Data bits
Note This setting is only valid if Connection is set to
COM .
Select the number of data bits in each character:
• 4 •
•
5 •
•
6 •
•
7 •
•
8. •
INSTALLATION
EPT077343 EN - Issue 1 - 11 November 2022 85