Domino Ax Series, User Documentation

Page: 99 / 167

OPERATION
EPT019297 Issue 1 November 2016 4-25
Reverse Mode
Reverse mode is used to reverse an individual label design as shown in the illustration below.
This setting can be configured to reverse the label design for a specified number of times, before
reversing the label back for the same number of times. Furthermore, this setting can be
configured to reverse the label when the printer’s user port is activated.
Notes: (1) A global reverse setting is available to reverse all label designs. However, the global
setting does not allow the number of reversed prints to be counted. Also, the global
setting does not allow reversed prints to be triggered by a user port, see
page 4-62 .
(2) If required, the label can also be inverted on the Print optimisation screen, see
page 4-9 .
To setup reverse mode for an individual label design:
(1) In the label creator’s side menu, select the Label tab.
(2) Select the Settings menu.
(3) Select the Reverse mode drop down setting.
(4) Select and configure one of the options described in the table below:
(5) Select the Save icon to save the setting.
End of procedure.
Setting Name Explanation
On - Always The label design will be reversed at all times.
On - Counted The label design will be reversed for a specified number of prints.
When this option is selected, the settings described below will
also be displayed:
Reverse: Initial orientation - Select the orientation of the first label
print.
Reverse repeat count - Select the number of times the label will
be printed in a reversed orientation.
On User port The label design will be reversed when the user port is activated.
Off The label design will not be reversed.