14
EN
Installation and Setup
STIIC Controller
2. Select
STIIC Setup 1
or
STIIC Setup 2
to view the
devices to enable/disable. If the vessel has more
than 10 room controls, additional room controls are
enabled through the RoomControl ##-## menus.
22
Main Menu Screen
3. Press Enter to select and go to the next screen.
23
Enable/Disable Screen
4. Use the scroll buttons to select a device. Press Enter
to update the number (0=disabled, 1=enabled).
24
Device Enabled Screen
5. Press Escape to go to the Main screen.
6. Repeat steps 1–5 to enable or disable other devices.
6 .3 .6 Using the LCD Display to Configure
Room Control
1. Press Program to enter the Main menu and scroll to
the room controls.
25
Main Menu Screen
2. Select a Room Control and press Enter.
I
The first selection in the Room Control screen is to
select a fan speed. Verify which model you have to
select the appropriate setting.
26
Room Control Screen
3. Press Enter to update the fan speed value
(0=3-speed, 1=5-speed).
27
Fan Speed Selection Screen
4. Repeat steps 1–3 for each room control.
6 .3 .7 Using the LCD Display to Assign IP
Addresses
The STIIC PLC can be setup to have a static IP address for
network configurations.
1. Press and hold Alarm and Enter for five seconds or
until the screen goes to the PLC menu.
28
Main Screen
2. Select
SETTINGS
.
29
Main Menu Screen
3. Select
TCP/IP SETTINGS
.