background image

 

- 1 -

 

 

Dometic Fridge Power Kit – 12 volt

                             

(Item code: RAPS12R-U2) 

 

Installation and Operating Instructions

 

 

 
 
Mounting 

 

1.  Locate a suitable position inside the vehicle to mount the control unit. It is 

recommended that the unit be mounted on the same side of the vehicle as 
the battery. 

2.  Fix the mounting plate to the vehicle using the double sided tape or screws 

provided. Ensure the mounting position provides sufficient access for the 
connection cable. 

 

Connection 

 

The connection cable is run directly from the vehicle’s battery to the control unit. An 
inline fuse (fitted to the cable) must be located at the battery end. It is recommended 
that you start the installation at the battery end. Do not fit the fuse until the wiring is 
complete. 
 

1.  Remove the fuse from the fuse holder. 
2.  Fit the positive wire (Red) to the positive (+) battery terminal with the supplied 

ring terminal.  

3.  Fit the negative wire (Black) to the negative (-) battery terminal with the 

supplied ring terminal. 

4.  Run the cable through the vehicle to the location of the control unit. When 

running the cable through metal panels ensure existing or new rubber 
grommets are used to prevent the metal panels from cutting through the 
cable insulation. The cable must not run near the exhaust pipe, other hot 
components or any moving parts. 

5.  Secure the cable with the supplied cable ties. 
6.  If there is excess cable remaining (Greater than 50cm) trim the excess cable 

and strip the wire sheath to expose 8mm of wire. 

7.  Connect the positive wire (Red) to positive (+) connection terminal on the 

base of the control unit. 

8.  Connect the negative wire (Black) to negative (-) connection terminal on the 

base of the control unit. 

9.  Slide the control unit on to the mounting bracket until there is a slight click. 

    10.  Refit the fuse (20Amp) to the fuse holder at the battery. 

 

 
 
 

Reviews: