Dometic MWO24, Operating Manual

Page: 11 / 176

MWO24 Troubleshooting
EN
11
• Regularly wipe the door, the door seals and the adjacent parts with a damp cloth to remove soiling or splashes.
• Do not allow the control panel to get wet. Clean it with a soft, damp cloth. Leave the door open to avoid acci-
dentally turning on the microwave oven.
• If moisture accumulates inside or around the outside of the door, wipe it dry with a soft cloth. This can occur if
the microwave oven is operated under high humidity conditions and is normal.
• Odours in the microwave oven can be removed by a cup of water and lemon juice and peels. Pour and place
them in a deep microwave-safe container and turn on the microwave oven for 5 minutes. Wipe it out thoroughly
and dry it with a soft cloth.
• Have a defective microwave lamp replaced by a specialist dealer.
• The microwave oven should be cleaned regularly and have any food scraps removed. Not maintaining the
device in a clean condition may damage the surface and shorten the service life of the device.
8 Troubleshooting
In case of failure of the microwave oven,
ERROR
appears on the display.
The following error codes are displayed on the display of the microwave oven:
Fault Remedy
The microwave oven does not
work. Make sure that the microwave oven is plugged in correctly. If it is not prop-
erly plugged in, unplug it, wait 10 seconds, and then plug the microwave
oven in correctly.
Check if a fuse is blown or a circuit breaker is tripped. If they are operating
properly, test the socket with another device.
Make sure that the microwave oven and the cooking time are set correctly.
Check whether the door is properly closed. Otherwise, the microwaves do
not reach the interior of the microwave oven.
Error code Fault Explanation/remedy
F.01 Overcurrent protection tripped
➤
Press the button for more than 3 seconds to turn off
the microwave oven.
➤
Contact the manufacturer’s branch in your country (see
the back of the instruction manual for the addresses) or
your specialist dealer.
F.02 Door not closed
➤
Close the door of the microwave oven.
If the error code is still displayed, then the temperature pro-
tection is enabled. Proceed as follows:
➤
Press the button for more than 3 seconds to turn off
the microwave oven.
➤
Ensure that the product is sufficiently ventilated.
➤
Wait at least 10 minutes before you put the microwave
oven back into operation.
➤
If the error code continues to be displayed, contact the
manufacturer’s branch in your country (see the back of
the instruction manual for the addresses) or your special-
ist dealer.
DometicMWO24_OPM_4445101580_EMEA16_xxxx-xx-xx.book Page 11 Wednesday, July 6, 2022 6:44 PM