Dometic I-Lux, Installation And Operating Manual

Page: 6 / 28

EN
Installation I-Lux
6
6 Installation
6.1 Preparing the installation
1. Before installation, check the wall thickness of your vehicle. Consult the vehicle
manufacturer if you have any questions.
2. When choosing the installation location, observe the following:
– Adjoining components (attachment and reinforcing parts), cables and cabi-
nets in the vehicle interior must not get damaged when sawing the hole.
– Sufficient space needs to be available for installing the inner and outer frames.
– Only install the window on flat wall surfaces.
6.2 Cutting out the wall hole
See fig.
2
6.3 Installing the reinforcing rails (optional)
Supplementary to fig.
3
1. Before installation, check whether the wall hole needs reinforcing.
2. Remove the foam/insulation according to the width of the reinforcing rails (not in
scope of delivery) ( A ).
3. Fit the reinforcing rails ( B ).
6.4 Installing the vent window
Supplementary to fig.
4
➤
Measure the wall thickness W.
See fig.
5
➤
Clean the wall section in the installation area with a soft, damp cloth.
See fig.
6
A
➤
Seal the outer frame with a flexible, non-hardening butyl cord (diameter 6 mm) or
a flexible non-hardening sealing compound (e.g. SikaLastomer-710).
Start and end in the lower area.
NOTICE! Damage hazard
Observe the sealant manufacturer's instructions.