Dometic CT 4050, Operating Manual

Page: 25 / 296

EN
CT(E), CTLP, CT(E)S, CTW Cleaning and greasing
25
8 Cleaning and greasing
A
➤
Clean and grease all seals on the toilet and cassette tank regularly. In case of fre-
quent use, perform these actions monthly or after 3 – 5 drainings of the cassette.
Use grease or silicone-based spray.
The manufacturer recommends:
– Grease: OKS
®
1110
– Silicone spray: OKS
®
1111
➤
Clean the toilet regularly inside and out with a soft cloth and lukewarm water with
a mild colorless cleaning agent. Then wash the surfaces with clear water.
8.1 Greasing the slider rods
!
The slider moves smoothly when it is regularly lubricated.
➤
Spray the slider rods with silicone spray (fig.
c
, page 9).
8.2 Greasing the cassette seal
1. Remove the cassette tank and place it on a firm surface (fig.
d
, page 9).
2. Unlatch the slider handle and pull it out (fig.
e
, page 9).
3. Turn the slider anti-clockwise and release it from the cassette (fig.
f
, page 10).
4. Push back the cover so that the seal is accessible (fig.
g
, page 10).
5. Clean and grease the seal.
!
6. Close the cover (fig.
k
, page 11).
7. Place the slider back on.
NOTICE! Damage hazard
• Cleaning agents for the toilet may not contain chlorine or alcohol.
• To prevent material changes, do not use hard, abrasive or
soda-based cleaning agents (scouring agents).
• Do not use polish for cleaning.
CAUTION! Risk of crushing
When the slider is closed during cleaning or greasing, there is a risk of
crushing body parts (fig.
b
, page 8).
CAUTION! Risk of crushing
Do not reach into the opening when you close the cover.