Dometic CRE0050, Installation And Operating Manual

Page: 23 / 348

EN
CRE Installing and connecting the refrigerator
23
7.6 Replacing the door panel
A
The decorative trim has the following measurements (see fig.
0
, page 8):
Removing and installing the decorative trim
➤
Proceed as shown (fig.
a
, page 8 to fig.
c
, page 10) to remove the decorative
trim.
➤
Proceed in reverse sequence to install the decorative trim.
7.7 Connecting the refrigerator to DC voltage
A
The refrigerator can be operated with DC voltage supply (12/24 V
g
).
For safety reasons, the refrigerator is equipped with an electronic system to prevent
the polarity being reversed. This protects the refrigerator against reversed polarity
when connecting to a battery and against short circuiting.
To protect the battery, the refrigerator switches off automatically if the voltage is
insufficient (see table below).
NOTICE! Risk of damage!
The door panel must be replaced only when the refrigerator is upright.
Model A B C
CRE0050 350 ± 0.5 mm 474 ± 0.5 mm 0.5 mm
CRE0065 419 ± 0.5 mm 468 ± 0.5 mm
CRE0080 445 ± 0.5 mm 582 ± 0.5 mm
NOTICE!
• To avoid voltage drops and loss of performance, keep the
connection cable as short as possible.
Avoid additional switches, plugs or power strips.
• Disconnect the cooling device and other electric consumers from
the battery before you connect the battery to a quick charging
device. Overvoltage can damage the electronics of the device.
12 V 24 V
Cut-off voltage
10.4 V 22.8 V
Cut-in voltage
11.7 V 24.2 V
CRE50-65-80_IOM_EMEA16.book Seite 23 Mittwoch, 30. September 2020 10:50 10