Dometic CDF-11, Operating Manual

Page: 18 / 248

EN
Troubleshooting CoolFreeze CDF11
18
9 Troubleshooting
10 Disposal
➤
Place the packaging material in the appropriate recycling waste bins wherever
possible.
M
If you wish to finally dispose of the product, ask your local recycling centre
or specialist dealer for details about how to do this in accordance with the
applicable disposal regulations.
Fault Possible cause Suggested remedy
Device does not function,
“POWER” LED does not
glow. There is no voltage
flowing from the DC
power socket in your
vehicle. There is no voltage flowing from the
DC power socket in your vehicle.
The device does not cool
(plug is inserted, “POWER”
LED is lit). Defective
compressor. This can only be repaired by an
authorised repair centre.
The device does not cool
(plug is inserted, “POWER”
LED flashes, the display is
blank). Battery voltage is too
low. Check the battery and charge if
necessary.
Check the wiring and connections.
When operating from the
DC power socket:
The ignition is on and the
cooling device is not
working.
The fitting of the DC
power socket is dirty.
This results in a poor
electrical contact. If the plug becomes very warm in the
DC power socket fitting, either the fit-
ting must be cleaned or the plug has
not been assembled correctly.
The fuse of the DC
plug has blown. Replace the fuse of the DC plug with
one of the same rating.
The vehicle fuse has
blown. Replace the vehicle's DC power
socket fuse. Please refer to the operat-
ing manual of your vehicle.
“ERROR” LED flashes and
the display shows “ERR1”
or “ERR2”. Device is defective. This can only be repaired by an author-
ised repair centre.
CDF11-O-16s.book Seite 18 Montag, 18. Mai 2020 1:42 13