MT 5000iQ
Using the device
EN
13
The actual values (fig.
8
) and the corresponding measurement units (fig.
9
) are displayed in the following order:
• The voltage of the starting and house battery
• The current load or charge of the house battery
I
• The capacity of the house battery
• The remaining running time of the house battery
I
9.2
Displaying environmental information
➤
To scroll through the environmental information, shortly press the
HOME
2
) but-
ton.
The actual values (fig.
8
) and the corresponding measurement units (fig.
9
) are displayed in the following order:
1. Time
2. Date
3. Inside temperature
4. Minimum inside temperature
5. Maximum inside temperature
6. Outside temperature
I
7. Minimum outside temperature
8. Maximum outside temperature
9.3
Stand-by mode
The device must be permanently supplied with power so that the capacitance can be measured
continuously.
NOTE
When the current flows to the battery, a positive value is displayed and the
CHARGE
text
appears on the display (fig.
7
). If the current flows from the battery, a neg-
ative value is displayed.
NOTE
When charging the battery, the remaining running time cannot be calculated and
-.-
is
displayed (fig.
8
). When there is consumption from the battery, the
remaining running time will be displayed in
hh:mm
form. If not, check for correct setup
threshold settings.
NOTE
If no outside temperature sensor is connected or the battery control booster function
is selected,
-.-
appears on the display (fig.
8
).
