Rev 0-25 11 19
Fabriqué en Chine
Page 25
ASSEMBLING THE WHEELS
turn the air cooler
upside down on a
flat surface after ca
-
refully preparing the
surface by covering
it with a blanket, or
other protection, so as not to scratch the
top of the unit.
Take the 4 swivel wheels and insert them
in the appropriate slots. Caution: the
wheels with brakes must be positioned
at the front of the unit. The wheels wit
-
hout brakes must be positioned at the
rear of the unit.
Make sure that the wheel axles are cor
-
rectly positioned in their slots and tigh-
ten them with an open-ended spanner.
Put the unit on its wheels and place it on
a flat and stable surface.
FILLING THE TANK
Refer to the drawings in the description
above.
The filling is done either by the upper
tank, or by directly filling the lower tank.
The 2 tanks are linked. That is, when
water is added to the upper tank, it flows
by gravity into the lower tank. When
operating in air humidifying mode, water
is pumped into the lower tank to feed
the upper tank and then used to humi-
dify the surrounding air. when the air
humidifying mode is disengaged, the
pump stops and the remaining water in
the upper tank flows into the lower tank.
IMPORTANT:
When adding water to
the top tank, always make sure that the
maximum level is never exceeded by
monitoring the water level window.
To fill using the upper tank, simply lift the
lid (1) and monitor the level window (6).
To fill using the lower tank:
1. Turn the tank retaining tab.
2. Partly remove the tank from the unit.
3. For a cooler effect, place the free-
zer blocks provided (2) or ice cubes
in the tank before filling (important,
otherwise there is a risk of overflow).
4. Fill the tank.
5. Replace the tank. take care to lock it
with the retaining tab.
IMPORTANT:
- the water for refilling must always be
ReMindeR: unPluG the aPPlianCe BeFoRe FillinG, seRViCinG oR othe-
Rwise handlinG it
