CONNECTION
NOT-PREMIUM rev 02
Wiring diagram
Assembling the shore
power connector
7
STEP 1:
Remove approx 2 cm of the outer sheath
Remove approx 8 mm of the inner wires’ sheaths
Tinplate the bare copper ends
7
STEP 2:
Remove the security cap using an utility knife
7
STEP 3:
Pull the conductor through the pre latched strain
relief housing
7
STEP 4:
Open the clamp with a screwdriver and insert the first
cable up to the stop. Repeat this step for all three cables.
7
STEP 5:
Latch the connector on to the strain relief housing.
7
STEP 6:
Snap together the upper and lower parts of the strain
relief housing and tighten it using the screw.
Dispatching
