DOLD SAFEMASTER S UH 6932, Operating Instructions Manual

Page: 49 / 52

49
UH 6932 / 21.08.18 de / en / fr / 010A
Device: UH 6932
Device No: . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Configurated by: . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Date: . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
1. Parameterization
1.1 Monitoring function
Overspeed
Underspeed
Inside range
Outside range
Esc OK
1.2 Limits
Frequency mode 1
1)
upper limit
2)
Hz
lower limit
3)
Hz
Frequency mode 2
1)
upper limit
Hz
lower limit
Hz
Frequency mode 3
upper limit
Hz
lower limit
Hz
Frequency mode 4
upper limit
Hz
lower limit
Hz
Esc OK
1.3 Hysteresis
%
Esc OK
1.4 Time Delay
Start-up delay
s
Response delay
s
Alarm delay
s
Changeover bridging
1)
s
Esc OK
1.5 Alarm memory
Alarm memory
automatic reset
Esc OK
1.6 Muting function
activate
deactivated
Esc OK
Esc
OK
Please cut off and file it !

Parameterization using the display
To enter the device’s parameterization mode the following key combination
is provided:
Press and keep pressed the right key at first. Then, press the left key (see
below). A display test follows and has to be acknowledged using the OK
key (right key) when it was successful. Then, it is possible to change the
parameterization. Before the device adopts changed parameters, they must
be confirmed once more for safety reasons.
1)
only available at variant /_ _1.
2) not available at monitoring function „underfrequency“.
3)
not available at monitoring function „overfrequency“.
M11259
actual frequency
100Hz
2. 1.
Formular for documentation of the setting parameters
Parameterization