Configurable Safety System SAFEMASTER PRO
77
0265525 / 16.05.19 en / 101A
CREATE A NEW PROJECT (CONFIGURE THE SAFEMASTER PRO SYSTEM)
Select icon CREATE
from the standard tool bar to start a new project
.
The user authentication window is displayed.
Next the SAFEMASTER PRO DESIGNER displays a window showing the UG 6911.12/080 only. It is possible
to select the control module UG 6911.10 acting on the drop-down menu under the master module choosing the
FW version. For UG 6911.10 it is < 5.0, for UG 6911.12/080 it is
≥
5.0.
You may add the various units needed to create your system, using the pull-down menus at the top of the screen
(select slave) and at the bottom to select the relative node (0÷3).
Selection of installed firmware in the control unit that should be configured
(
≤
0.3,
≥
0.4 < 1.0,
≥
1.0 < 2.0,
≥
2.0 < 3.0 or
≥
3.0).
See also section
"System composition“.
