Configurable Safety System SAFEMASTER PRO
192
0265525 / 16.05.19 en / 101A
Click on the icon
to start the graphic simulation.
Graphic simulation can be used to display the signal pattern over time in a graph. First you must define the stimuli
in a specific text file: this means defining the trend over time in the waveforms used as inputs (stimuli). Based on the
stimuli file created, the simulator injects these into the diagram and displays the traces required in order to perform
the simulation.
When the simulation is complete, a graph like the one shown below is automatically displayed. From the graph you
can print the traces displayed ("Print"), save the results in order to load them again later (Save) or display other traces
("Change visibility"). The names of the traces match the description of the function blocks.
Example of a result of the graphic simulation
The simulation can only be carried out after performing at least the following steps:
1. Create a stimuli file to suit your needs
2. Upload the stimuli file and wait until the simulation finishes
Click on the icon
to display the page shown below:
Menu for selecting the
graphic simulation mode
GRAPHIC SIMULATION
