Configurable Safety System SAFEMASTER PRO
85
0265525 / 16.05.19 en / 101A
CONNECT TO SAFEMASTER PRO
SENDING THE CONFIGURATION TO THE SAFEMASTER PRO
CONFIGURATION LOG
DOWNLOAD A CONFIGURATION FROM A SAFEMASTER PRO
After connecting the control unit UG6911.10 to the PC via CSU cable OA 6920 (USB) use the icon
for the
connection. A window appears to request the password. Enter the password (see "Password protection ").
To send the saved configuration from a PC to UG6911.10 (or UG6911.12/080) use the icon
on the
standard toolbar and wait the execution. The control unit will save the project in its internal memory and
(if present) in OA 6911 memory. (Password Required: level 2).
Use the icon
on the Standard toolbar to download a project from SAFEMASTER PRO to
SAFEMASTER PRO Designer. (Password level 1 is sufficient).
The log file can be visualized using the icon
in the standard tool bar. (Password Required: level 1).
This function is possible only after the project validation with OK result.
If the firmware version in the control unit is not identical to the selected
firmware version of the configuration file, a failure message is displayed
as shown right (example) and the configuration is not transferred.
.
To transfer the configuration, the configuration file has to be set to the
same firmware status as it is installed in the control unit. See also section
"Create a new project (configure the SAFEMASTER PRO system)".
Within the configuration file (project), are included the
creation date
and
CRC (4-digit hexadecimal identification)
of a project that are stored in
UG 6911.10 (or UG 6911.12/080).
This logbook can record up to 5 consecutive events, after which these are
overwritten, starting from the least recent event.
