Figure 5: Setting the time
4.4.2 Adding a Network Time Protocol server
You can add a Network Time Protocol (NTP) server.
About this task
This feature allows the Dolby IMS3000 to correct its possibly drifted time by syncing with a
specified NTP server at every boot and every morning at 6:25 AM if the server is on.
Procedure
1. Click
Setup & Maintenance
.
2. Click
System Settings
.
3. Click
Date and Time
.
4. Click
Add
in the
NTP Servers section
.
5. Enter the extra delay value (if needed) in
Extra delay (seconds)
.
6. Enter the IP address of the NTP server in the empty field below, and then click
Test
.
7. Click
Save
.
Setting up the Dolby IMS3000
Dolby IMS3000 User
ʼ
s Manual
10 December 2018 IMS.OM.005280.DRM Issue 4
23
