Figure 16: Aiming for the reference listening position (RLP) overhead view
3.4 Working with electrical components
To be sure that the speakers work correctly, you must connect all electrical components properly.
You will need a wire stripper to complete some tasks here.
Caution: Turn off all amplifiers when connecting loudspeaker wiring.
The Dolby Speaker System 128 connectors accept an American Wire Gauge (AWG) of 18 AWG to 6 AWG (1 mm2
– 16 mm2). Typically, a wire gauge of 16 AWG to 12 AWG (1.5 mm2 – 4 mm2) is recommended. The following
sections provide basic information regarding Dolby Speaker System 128 input plates, choosing between the
two modes of operation, installing the wiring, and detailed information regarding speaker operating modes.
3.5 Connecting and configuring the CS128MH
This section provides information on how to connect and configure the CS128MH.
About this task
To be sure speakers work correctly, you must connect all electrical components properly. You will need a wire
stripper to complete some tasks in this section.
Caution: Turn off all amplifiers when connecting loudspeaker wiring.
Assembling the Dolby Speaker System 128
Dolby Speaker System 128 Owner's Manual
22
8800293 Issue 2
27 October 2021
