1
Product Features and Operating Instructions
DogWatch
®
IB-
200
The IB-
200
is a dual function transmitter designed to be used either
as a wireless unit that emits a signal directly from the transmitter
without the use of a boundary wire o
orr it may be installed with a
boundary wire to establish larger or multiple avoidance areas.
Set Up: Wireless / With Wire
The INT/EXT switch on the back of the unit allows you to choose your preferred application.
You cannot use
both applications at the same time.
INT
allows you to use the transmitter as a
wireless
unit.
EXT
allows you to use the transmitter
with boundary wire
.
Wireless:
When using the IB-200 as a wireless unit (
INT
)
, place the unit in the area that you want your pet to avoid.
The signal range can be adjusted up to
a maximum of 10 feet in diameter
(5 feet in all directions from the
transmitter).
Avoid placing the transmitter on or near large metal objects.
With Wire:
When using the boundary wire (
EXT
)
, you can customize your avoidance zone(s)
and adjust the signal range using both the Signal Range adjustment and by increasing or
decreasing the distance between the separated wires. See instructions on page 3.
EXT WIRE
Boundary wire
attachment
INT - Wireless
EXT - Wired
Power Status Light
Frequency
(for Dealer Use Only)
®
IB-200 T
RANSMITTER
T
OP
B
OTTOM
Signal Range
Power Status Light
The Power Status Light on the top of the transmitter turns “on” and glows
green when the transmitter is plugged-in and sending a signal.
When using
a boundary wire, the Power Status Light turns “on” only when there is a
continuous signal loop.
See instructions on page 3.
Note: The green light may be steady green or blinking green. This depends
of the Frequency setting of the transmitter.
Signal Range
Signal
range
is the
distance the signal radiates
from the transmitter or
the boundary wire.
•
Turn the knob toward the
‘+’
to increase the signal range.
This increases the size of the signal field.
•
Turn the knob toward the
‘-’
to decrease the signal range.
This decreases the size of the signal field.
Never adjust the signal range while your pet is wearing the receiver
collar. Always test the signal field and mark the edge of the field with
warning flags before allowing your pet near the boundary area.
Frequency
This switch controls the broadcast frequency of the signal. Your Dealer will
set this switch for your system.
Do
NOT
change this setting. It is for
DEALER USE ONLY
.
