Dodge Viper 2017, Operating Information Manual

Page: 12 / 389

A WORD ABOUT YOUR KEYS
Your vehicle uses a keyless ignition system.
This system consists of a key fob with Remote
Keyless Entry (RKE) Key Fob and a Keyless
Push Button Ignition.
Keyless Enter-N-Go Feature
This vehicle is equipped with the Keyless Enter-
N-Go ignition feature.
Keyless Push Button Ignition
This feature allows the driver to operate the
ignition with the push of a button, as long as the
Remote Keyless Entry key fob is in the passen-
ger compartment.
The Keyless Push Button Ignition has four op-
erating positions; three of which are labeled and
will illuminate when in position. The three posi-
tions are OFF, ACC, and ON/RUN. The fourth
position is START, during start RUN will illumi-
nate.
NOTE:
In case the ignition does not change with the
push of a button, the key fob may have a low
or dead battery.
Key Fob
The key fob also contains the Remote Keyless
Entry key fob and an emergency key, which
stores in the rear of the key fob.
The emergency key allows for entry into the
vehicle should the battery in the vehicle or the
key fob go dead. You can keep the emergency
key with you when valet parking.
To remove the emergency key, slide the me-
chanical latch on the back of the key fob side-
ways with your thumb and then pull the key out
with your other hand.
NOTE:
In the event that the FOB does not start the
vehicle (
ⴖ
FOB not Found
ⴖ
message) use the
FOB nose (furthest point from key ring) and
push the start button. FOB replaces the
finger.
Keyless Push Button Ignition
1 — OFF
2 — ACC (ACCESSORY)
3 — ON/RUN
Remote Keyless Entry Key Fob
Emergency Key Removal
9