STARTING AND OPERATING
29
Shifting Procedure
NOTE:
If any of the requirements to select a new
transfer case position have not been met, the
transfer case will not shift. The position indi
-
cator light for the previous position will
remain on and the newly selected position
indicator light will continue to flash until all
the requirements for the selected position
have been met.
If all the requirements to select a new
transfer case position have been met, the
current position indicator light will turn off,
the selected position indicator light will flash
until the transfer case completes the shift.
When the shift is complete, the position indi
-
cator light for the selected position will stop
flashing and remain on.
S
ELEC
-S
PEED
C
ONTROL
(SSC)
Selec-Speed Control Switch
SSC is intended for off-road driving in 4WD Low
only. SSC maintains vehicle speed by actively
controlling engine torque and brakes.
NOTE:
For vehicles not equipped with Trailer Reverse
Steering Control (TRSC), your SSC switch is
located on the Auxiliary Switch Bank below your
radio screen.
SSC has three states:
1. Off (feature is not enabled and will not
activate)
2. Enabled (feature is enabled and ready but
activation conditions are not met, or driver
is actively overriding with brake or throttle
application)
3. Active (feature is enabled and actively
controlling vehicle speed)
Enabling SSC
SSC is enabled by pushing the SCC switch when
the following conditions are met:
The driveline is in 4WD Low.
The vehicle speed is below 5 mph (8 km/h).
The parking brake is released.
The driver door is closed.
The driver is not applying throttle.
4
21_DT_TRX_SU_EN_USC_t.book Page 29
