Dodge Charger SRT 392 2017, Operating Information Manual, Page: 190 / 576

(8 km/h) before the engine will shut off. The
ignition switch position will remain in the ACC
position until the gear selector is in PARK
and the button is pushed twice to the OFF
position. If the gear selector is not in PARK
and the ENGINE START/STOP button is
pushed once, the instrument cluster display
will display a “Vehicle Not In Park” message
and the engine will remain running. Never
leave a vehicle out of the PARK position, or it
could roll.
4. If the gear selector is in NEUTRAL, push and
release the ENGINE START/STOP button
with the vehicle speed below 5 mph (8 km/h)
before the engine will shut off. The ignition
will remain in the ACC position.
NOTE:
If the ignition is left in the ACC or ON/RUN
(engine not running) position and the transmis-
sion is in PARK, the system will automatically
time out after 30 minutes of inactivity and the
ignition will switch to the OFF position.
ENGINE START/STOP Button Functions —
With Driver’s Foot OFF The Brake Pedal (In
PARK Or NEUTRAL Position)
The ENGINE START/STOP button operates
similar to an ignition switch. It has three posi-
tions, OFF, ACC, RUN. To change the ignition
switch positions without starting the vehicle and
use the accessories follow these steps:
1. Starting with the ignition in the OFF position:
2. Push the ENGINE START/STOP button
once to change the ignition to the ACC
position.
3. Push the ENGINE START/STOP button a
second time to change the ignition to the
RUN position.
4. Push the ENGINE START/STOP button a
third time to return the ignition to the OFF
position.
Extreme Cold Weather (Below –22°F
Or −30°C)
To ensure reliable starting at these tempera-
tures, use of an externally powered electric
engine block heater (available from your autho-
rized dealer) is recommended.
If Engine Fails To Start
WARNING!
•
Never pour fuel or other flammable liquid
into the throttle body air inlet opening in an
attempt to start the vehicle. This could
result in flash fire causing serious personal
injury.
(Continued)
WARNING! (Continued)
•
Do not attempt to push or tow your vehicle
to get it started. Vehicles equipped with an
automatic transmission cannot be started
this way. Unburned fuel could enter the
catalytic converter and once the engine
has started, ignite and damage the con-
verter and vehicle.
•
If the vehicle has a discharged battery,
booster cables may be used to obtain a start
from a booster battery or the battery in an-
other vehicle. This type of start can be dan-
gerous if done improperly. Refer to “Jump-
Starting Procedures” in “What To Do In
Emergencies” for further information.
Clearing A Flooded Engine (Using ENGINE
START/STOP Button)
If the engine fails to start after you have followed
the
“Normal Starting” or “Extreme Cold
Weather " procedures, it may be flooded. To
clear any excess fuel:
1. Press and hold the brake pedal.
2. Press the accelerator pedal all the way to the
floor and hold it.
3. Push and release the ENGINE START/
STOP button once.
187