Dodge Charger SRT 392 2017, Operating Information Manual, Page: 19 / 576

1. Remove the emergency key by sliding the
mechanical latch on the back of the key fob
sideways with your thumb and then pull the
key out with your other hand.
2. Insert the tip of the emergency key or a
#2 flat blade screwdriver into the slot and
gently pry the two halves of the key fob apart.
Make sure not to damage the seal during
removal.
3. Remove the battery by turning the back
cover over (battery facing downward) and
tapping it lightly on a solid surface such as a
table or similar, then replace the battery.
When replacing the battery, match the + sign
on the battery to the + sign on the inside of
the battery clip, located on the back cover.
Avoid touching the new battery with your
fingers. Skin oils may cause battery deterio-
ration. If you touch a battery, clean it with
rubbing alcohol.
4. To assemble the key fob case, snap the two
halves together.
DOOR LOCKS
Manual Door Locks
To lock each door, push the door lock knob on
each door trim panel downward. To unlock the
front doors, pull the inside door handle to the
first detent. To unlock the rear doors, pull the
door lock knob on the door trim panel upward.
If the door lock knob is down when you shut the
door, the door will lock. Therefore, make sure
the key fob is not inside the vehicle before
closing the door.
WARNING!
•
For personal security and safety in the
event of a collision, lock the vehicle doors
before you drive as well as when you park
and leave the vehicle.
(Continued)
Emergency Key Release
1 — Emergency Key Release Button
2 — Emergency Key
Separating Key Fob Case
Door Lock Knob
16