Dodge 2016 Challenger, Operating Information Manual

Page: 274 / 737

Using The Mode Select Knob And Hoses
Your Tire Service Kit is equipped with the follow-
ing symbols to indicate the air or sealant mode.
Selecting Air Mode
Push in the Mode Select Knob (5) and
turn to this position for air pump opera-
tion only. Use the Black Air Pump Hose
(7) when selecting this mode.
Selecting Sealant Mode
Push in the Mode Select Knob (5) and
turn to this position to inject the Tire
Service Kit Sealant and to inflate the
tire. Use the Sealant Hose (clear hose) (6) when
selecting this mode.
Using The Power Button
Push and release the Power Button (4)
once to turn On the Tire Service Kit.
Push and release the Power Button (4) again to
turn Off the Tire Service Kit.
Using The Deflation Button
Push the Deflation Button (2) to reduce
the air pressure in the tire if it becomes
over-inflated.
Tire Service Kit Usage Precautions
•
Replace the Tire Service Kit Sealant Bottle
(1) and Sealant Hose (6) prior to the expira-
tion date (printed at the lower right hand
corner on the bottle label) to assure optimum
operation of the system. Refer to “Sealing a
Tire with Tire Service Kit” section (F) “Sealant
Bottle and Hose Replacement”.
•
The Sealant Bottle (1) and Sealant Hose (6)
are a one tire application use and need to be
replaced after each use. Always replace
these components immediately at your origi-
nal equipment vehicle dealer.
•
When the Tire Service Kit sealant is in a
liquid form, clean water, and a damp cloth will
remove the material from the vehicle or tire
and wheel components. Once the sealant
dries, it can easily be peeled off and properly
discarded.
•
For optimum performance, make sure the
valve stem on the wheel is free of debris
before connecting the Tire Service Kit.
•
You can use the Tire Service Kit air pump to
inflate bicycle tires. The kit also comes with
two needles, located in the Accessory Stor-
age Compartment (on the bottom of the air
pump) for inflating sport balls, rafts, or similar
inflatable items. However, use only the Air
Pump Hose (7) and make sure the Mode
Select Knob (5) is in the Air Mode when
inflating such items to avoid injecting sealant
into them. The Tire Service Kit Sealant is only
intended to seal punctures less than 1/4 inch
(6 mm) diameter in the tread of your vehicle.
•
Do not lift or carry the Tire Service Kit by the
hoses.
Tire Service Kit Expiration Date Location
271